Get Adobe Flash player

Organizing Things For Decoupage

Wood

Lightly sand any rough spots. Fill rough stains and holes with wood filler and then sand. Wipe with a damp sponge. If you'd like a stained backdrop, utilize a water-soluble, engineered wood blot. You might have to seal the timber.

You are able to apply your own cutout right onto untreated wood, however it is far better to apply a sealer. Before trimming wood paint a base coat because the water-based paint lifts the fibers timber way from the outside if you sand the paint that the fibers can easily be eliminated. The initial coat of paint highlights imperfections which you are able to fix with filler.

When using a timber foundation, do not forget that water and oil do not mix. The most frequently encountered decoupage glazes are water-based and will not adhere correctly to timber that's been stained using an abysmal blot.

If you have stained wood having an abysmal blot, then you have to seal it using an oil-based sealer. If you would like to decoupage a bit of old furniture and are not sure of this end, locate an inconspicuous spot to check your glaze.

Glass

Clean your glass thing with water and soap, rinse thoroughly, and wipe dry. Scrub the surface with rubbing alcohol or vinegar and let it dry prior to working on the surface. Do not touch the surface after it's been washed as oil from hands may make your pictures not to seal correctly.

You have to be really careful to get rid of any excess adhesive from the glass surface, after your prints have been implemented. Additionally, it is extremely important to work on a fresh surface. When using PVA adhesive on glass, then add a drop of glycerin to lengthen the drying period. As soon as you've implemented your cutout into the glass surface and then let the adhesive to dry, then you are able to eliminate any glue by wiping the glass using a window cleaner. Do not apply adhesive to the picture, only into the glass. Do not be concerned about leaving too much adhesive between the glass and the picture since it will dry clean. The more adhesive you utilize, the easier it is to eliminate bubbles. In the same way, it is fine to make a thin film of adhesive on the glass and the rear of the picture.

Spray a little bit on a moist sponge or cloth and then remove any excess adhesive out of the glass. Cotton swabs work nicely to remove glue from small locations. If you want to learn more about Flex Seal, go to Flexreviews.

Vinyl

To decoupage on vinyl, you have to roughen the plastic with glue. This can give it a few tooth with which to catch and supply a tight seal. You'll have to allow additional drying and additional curing time compared to different surfaces. Dry to the touch is not enough. Gently press your finger into a place which will not reveal to examine it whenever possible. Otherwise, allow several days for drying to be on the secure side. Maintain the thing protected against dust while it's drying.